Dead ALL-H3-CC IoT version board?
Received ALL-H3-CC IoT Kickstarter kit on 6/17/18. Loaded Armbian_5.45_Tritium-h3_Ubuntu_xenial_next_4.14.44_desktop.img on the included SD card, installed card, plugged in included PS, but no output on HDMI monitor. Verified PS/Monitor with a RasPi 3, mounted SD card on Linux system to examine contents, which seemed to be there. Also tried attaching a USB serial port device to the board's serial port, but no output. I'm out of ideas - any suggestions?
Comments
What tool did you flash the MicroSD card with? If you used dd, do you have the exact command?
How do you have the UART hooked up? Is it a 5V or 3.3V UART cable? What did you set the baud rate, parity, and flow control to?
Just to close this out - a kind stranger on IRC suggested using Etcher. I used the CLI version, and was able to successfully boot my board. (I used exactly the same image with dd, so Etcher must have some extra magic :-))
Did you flash the first partition rather than the root device?