using a short eMMC 5.x module without screw holes

borrowedcarbon

Hi everyone,
I received an eMMC 5.x module for the la write S805X-AC -- without screw holes for attachment. It does 'snap' into the connector. Should I be attaching it somehow or worried about it coming loose?
Thank you

loverpi

Should be fine. Just put a tape on the bottom so that the components don't short circuit.

Alwilson

They should deliver what is ordered. It should not be necessary to use tape to fit a part correctly!
I just received the same board - with no fixing kit (other than what came with the La Frite). The screws that came with the La Frire go right through the brass washer and out the other side, leaving no way to use the washers which provide the spacing between the eMMC and the La Frite. They have no customer service, and do not respond to emails or forum posts. Best advice - never buy from them again!

loverpi

There should be nuts to fit the washers on the other end.

VCR0

Yeaaaah, I put tape under mine, some surface mounts were making out with the eMMC haha.  Electrical tape, so good.