POE Hat for Raspberry PI

Legit_Meter

I received the hat but it doesn't seem to fit the GPIO pins...  Please post some pictures or instructions!

loverpi

Can you take a picture of what you received and the board?

coldiso

Hi I have the same issue - sold on amazon says it is compatible with pi4 and pi3 B+, but no instructions and I don't see how to connect this:

loverpi

Just push it onto the board? See the picture on the box.

RickHolc

Just line it up and push it on. This is a photo of the hat installed on a 3b+  Nevermind the photo wont upload.

RickHolc

Any idea when these will come back in stock? I need (16) of them.

loverpi

RickHolc said:

Any idea when these will come back in stock? I need (16) of them.

They should be back in stock.

eewarlord

I noticed that the compact version is no longer listed on Amazon; only the "professional" variant is:  https://www.amazon.com/LoveRPi-Power-Over-Ethernet-Raspberry-Professional-Isolated/dp/B07XB5PR9J 
Is this an inventory problem or has the "compact" variant" been discontinued?  

loverpi

There's a supply chain disruption due to the current events.

eewarlord

Thanks for the clarification.  I'm glad to hear the compact version hasn't been discontinued.

kboutelle

I needed the pinout for this board and realized I could zoom in to the image above. Thanks. 

loverpi

@eewarlord Stock is available now.

sjdmd

OK. I've got the professional version working on my RPi 4B w/Ubiquiti POE af/at. Sitting out on the desk. My question: When my fan case gets here tomorrow, where do I plug the fan in given that the usual pins are covered by the block of six socket on the GPIO? I'm going to assume the "professional" version of the board pinout (not printed on the board) is the same as the "compact" version of the board with the added on 4x2-pin header rotated 90-degrees and the outboard most being at GND, then 3V3 and 5V, and so forth. Thanks. /Steve

loverpi

@sjdmd It is printed out on the board. It is a direct passthrough as the normal pins except there were two ground pins at the very top to make it easy to connect.

sjdmd

I have the professional model. It is NOT printed on the board. I figured it out. Your product may work fine. Your documentation and customer service are low quality in my opinion and I'll be saying so on Amazon.

loverpi

It should be under the headers per the photo: https://www.amazon.com/dp/B07XB5PR9J
Can you share a photo of the product you received?